Important Safety Information; Safety Instructions - Danby Designer DPA110B2WDD Guide D'utilisation Et Soins De Propriètaire

Important Safety Information

READ AND FOLLOW ALL SAFETY INSTRUCTIONS
FOR YOUR SAFETY: Read these instructions carefully before operating the unit and keep them for future reference.
SAFETY
PRECAUTIONS
ALWAYS DO THIS
Your air conditioner should be used in such a way that it is protected
from moisture. e.g. condensation, splashed water, etc. Do not place or
store your air conditioner where it can fall or be pulled into water or
any other liquid. Unplug unit immediately if this occurs.
Always transport your air conditioner in a vertical position and place
on a stable, level surface during use. If the unit is transported laying
on it's side it should be stood up and left unplugged for 4 hrs.
Turn off the unit when not in use.
Always contact a qualified person to perform repairs. If the power cord
is damaged it must be repaired by a qualified technician.
Keep clearance of at least 30cm all around the unit from walls, furni-
ture and curtains.
If the air conditioner is knocked over during use, turn off the unit and
unplug it immediately.
Always use the button on the control panel to turn off unit.
Portable air conditioners exhaust large amounts of room air. Always
ensure an adequate supply of make-up air to operate efficiently.
NEVER DO THIS
Do not operate your air conditioner in a wet room such as a bathroom
or laundry room.
Do not touch the unit with wet or damp hands.
Do not press the buttons on the control panel with anything other than
your fingers.
Do not remove any fixed components. Never use this appliance if it is
not working properly, or if it has been dropped or damaged.
Never use the plug to start and stop the unit.
Do not cover or obstruct the inlet or outlet grilles.
Do not use hazardous chemicals to clean or come into contact with
the unit. Do not use the unit in the presence of inflammable
substances or vapour such as alcohol, insecticides, petrol,etc.
Do not allow children to operate the unit unsupervised.
Do not use this product for functions other than those described in this
instruction manual.
3