Operating Instructions; Operating Modes - Danby Designer DPA110B2WDD Guide D'utilisation Et Soins De Propriètaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Instructions

OPERATING MODES

COOL mode
- Press the "MODE" button until the "COOL" indicator light comes on.
- Press the UP or DOWN arrow buttons to select your desired
room temperature. The temperature can be set within a range of
17°C-30°C / 62°F-86°F.
- Press the "FAN SPEED" button to choose the fan speed.
AUTO mode
- When you set the air conditioner in AUTO mode, it will automatically
select cooling, or fan only operation depending on what temperature
you have selected and the room temperature.
- The air conditioner will adjust the room temperature automatically to
the temperature point set by you.
- Under AUTO mode, you can not select the fan speed.
FAN operation
- Press the "MODE" button until the "FAN" indicator light comes on.
- Press the "FAN SPEED" button to choose the fan speed (1 time for LOW,
2 times for MEDIUM, 3 times for HIGH, 4 times for AUTO-FAN).
- The corresponding fan speed indicator light for each speed lights up. All
three indicators are lit up when AUTO-FAN is selected.
- The temperature cannot be adjusted.
- Do not use the window hose in this mode.
TIMER operation
- To initiate the "Auto-stop" program: When the unit is on, press the Timer
button, the TIMER OFF indicator light will illuminate.
- To initiate the "Auto-start" program: When the unit is off, press the Timer
button, the TIMER ON indicator light will illuminate.
- Press or hold the "UP" or "DOWN " buttons to change the Auto time by
0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24
hours.The control will count down the time remaining until the unit starts.
- The selected time will register in 5 seconds and the system will
automatically revert back to display the previous temperature setting.
- Turning the unit ON or OFF at any time or adjusting the timer setting
to 0.0 will cancel the Auto Start/Stop timed program.
- When a malfunction (E1,E2,E3, E4 or P 1) occurs, the Auto Start/Stop
timed program will also be cancelled.
8

Publicité

Table des Matières
loading

Table des Matières