Erasing All Tracks In Refresh Mode (Cd-Rw) - Teac CD-RW890 Mode D'emploi

Erasing in the refresh mode takes time. It is recommended to use
"ERASE DISC" when erasing all tracks.
A disc that causes an error during recording may be recovered by
erasing all tracks on the disc in the refresh mode.
1
Load a recorded CD-RW.
2
Press the ERASE button three times.
"REFRESH" appears on the display.
<
Each time the ERASE button is pressed, the display changes as
follows:
ERASE #
(#: The last track number)
ERASE DISC
REFRESH
Total number of tracks and total playback time
<
If only one track is recorded, "ERASE" and the last track number do
not appear. The display changes in the following order:
ERASE DISC
REFRESH
Total number of tracks and total playback time
< H) button to stop erasing if you need.
Press the Stop (
<
If a finalized disc is inserted, "UNFINALIZE" appears. To erase the
track(s), unfinalize the disc first.
24

Erasing All Tracks In Refresh Mode (CD-RW)

3
Press the Play (y) button to start erasing.
All tracks will be erased.
The time required appears on the display.
When the operation has been finished, the display returns to the
track/time display.
<
Never turn the power off nor unplug the power cord during
erasing.
<
During erasing, no buttons will work.
<
This operation cannot be undone. Before erasing the tracks, make
sure that you really want to erase them.