A-B Repeat; Programmed Playback - Teac CD-RW890 Mode D'emploi

A-B Repeat

You can play back the designate point of track repeatedly.
Start playback and designate the point at which the A-B repeat
should start (point A) by pressing the A-B button.
"REPEAT A-" blinks on the display.
When the point at which repeat playback should end (point B) is
reached, press the A-B button again.
The designated section will be played repeatedly.
<
The interval between points A and B must be 10 seconds or longer.
<
CD-R/CD-RW discs that have not been finalized cannot be used for
A-B repeat.
<
After designating point A, the Search (
used to fast-forward or fast-backward to point B.
Note that the point B should be forward the point A. Do not go
back beyond the point A.
< .//) buttons do not work during A-B repeat.
The Skip (
<
A-B repeat does not work during programmed playback and
shuffle playback.
<
Shuffle playback does not work during A-B repeat.
<
If one of the following buttons is pressed, A-B repeat will be
canceled:
A-B, Stop (H), OPEN/CLOSE (L), POWER
14
m/,) button can be

Programmed Playback (1)

Up to 32 tracks can be programmed in the desired order.
<
Insert a disc before beginning programming.
<
Programmed playback works with finalized discs only.
1
Press the PROGRAM button in the stop mode.
"PROGRAM" indicator blinks, and "0P00" appears on the display.
2
Press the numeric button to select a track.
track 7:
track 10:
The selected track is programmed. To program more than one
track, press the numbers subsequently.
track number program number
You can also use the Skip (.//) button and the PROGRAM
button to program tracks. Select a track using the Skip (.//)
button, and press the PROGRAM button. Repeat this step to
program other tracks.
<
If you made a mistake, press the CLEAR button. The last
programmed number will be deleted.
<
To stop programming, press the Stop (
indicator (PROGRAM) stops blinking and lights up. When the
PROGRAM button is pressed again, the "PROGRAM" indicator starts
blinking again, and you can continue programming.
total time of the programmed tracks
H) button. The program