Ryobi P3650 Manuel D'utilisation page 20

CUTTING WITH YOUR COMPOUND MITER
SAW
WARNING:
When using a work clamp or C-clamp to secure your
workpiece, clamp workpiece on one side of the blade
only. The workpiece must remain free on one side of the
blade to prevent the blade from binding in workpiece. The
workpiece binding the blade will cause motor stalling and
kickback. This situation could cause an accident resulting
in possible serious personal injury.
WARNING:
NEVER move the workpiece or make adjustment to any
cutting angle while the saw is running and the blade is
rotating. Any slip can result in contact with the blade
causing serious personal injury.
WARNING:
Do not try to cut narrow pieces using the sliding feature.
Failure to heed this warning could result in serious
personal injury.
TO MAKE NON-SLIDING CUTS
WARNING:
Securely tighten the slide lock knob when making any
non-sliding cuts. Failure to tighten the knob could result
in the saw head moving during the cutting operation.
TO MITER CUT/CROSS CUT
See Figures 27 - 28.
A cross cut is made by cutting across the grain of the
workpiece. A straight cross cut is made with the miter table
set at the 0° position. Miter cross cuts are made with the
miter table set at some angle other than 0°.
 Raise saw arm to its full height.
 Loosen the miter lock knob approximately one-half turn
and squeeze the detent release lever.
 Rotate the miter table until the pointer aligns with the
desired angle on the miter scale.
 Release the detent release lever, then tighten the miter
lock knob to secure the miter table.
NOTE: You can quickly locate 0°, 15°, 22-1/2°, 31.6°, and
45° left or right by releasing the detent release lever as
you rotate the miter table. The miter table will seat itself
in one of the positive stop notches, located in the miter
table base.
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
OPERATION
WORK
CLAMP
WORK
CLAMP
20 − English
CROSS CUT
MITER CUT
Fig. 27
Fig. 28