Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12.
Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If the connection lead is damaged, it must be
replaced by a special connection lead.
Contact your local WOLFF representative if you
have WOLFF power tools requiring repairs.
You can download a list of spare parts from
www.wolff-tools.com.
Always have your guard repaired by qualified personnel
only using genuine spare parts.
This will ensure that the safety of the guard is maintained.
13.
Environmental Protection
The generated grinding dust may contain harmful
substances. Dispose appropriately.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Directive 2002/96/EC
relating to electrical and electronic waste and
implementation of national law, used electrical tools must
be collected separately and disposed of in an
environmentally friendly manner at recycling
centres.
14.
Technical Specifications
Changes due to technological progress reserved.
Ø
= max. diameter of the accessory ................ 180 mm
M
= Spindle thread ................................................ M 14
n*
= no-load speed (maximum speed) .............. 6600 U
P1
rated input power ....................................... 2200W
P2
= power output .............................................. 1500W
m
= Weight without all accessory ....................... 9,2 kg
14.1
Come with
Concrete grinding BS 180........................... #15930
with safety cover
Diamond grinding disc ES K20 .................... #75407
Hearing protection..................................... #15315
Bar side handle ........................................ #82537
Safety gloves............................................. #15316
Carrying case........................................... #20938
Twin hole spanner..................................... #14961
Manual................................................... #82893
Spare parts list......................................... #82945
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~ AC Power
*Machines with the designation BS 180:
Energy-rich, high-frequency interference can cause
fluctuations in speed. The fluctuations disappear,
however, as soon as the interference fades away.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the emissions
from the power tool and to compare different power tools.
Depending on the operating conditions, the condition of
the power tool or the accessories, the actual load may be
higher or lower.
For assessment purposes, please allow for breaks and
periods when the load is lower. Based on the adjusted
estimates, arrange protective measures for the user e.g.
organisational measures.
Vibration total value(vector sum of three directions)
determined in accordance with EN 60745:
a
= Vibration emission value .......................4,5 m/s
h, SG
(surface grinding)
a
= Vibration emission value ........................ 3,6m/s²
h, DS
(sanding with sanding plate) ............... .... 2,5 m/s
K
= Uncertainty (vibration) .....................1,5 m/s
h,SG/DS/P
Typical A-effective perceived sound levels:
L
= Sound-pressure level ...................... 94,0 dB(A)
pA
L
= Acoustic power level ....................... 105,0 dB(A)
WA
K
, K
= Uncertainty ................................. 3,0 dB(A)
pA
WA
During operation the noise level
can exceed.
Wear ear protectors!
- 17 -
2
2
2
80,0 dB(A)
Publicité
Table des Matières
