Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Original instructions
1.
Declaration of Conformity
We declare under our sole responsibility that this product
is in conformity with the following
standards of standardization documents:
DIN EN 60745-1, DIN EN 60745-2-3,
according to the provisions of the:
2006/42/EC, 2004/108/EC, 2011/65/EU.
Authorised to issue this declaration and for
the gathering of the technical documentation.:
WOLFF GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde
2.
Specified Use
The angle grinders, when fitted with original WOLFF
accessories, are suitable for grinding, of concrete, stone
and similar materials without the use of water.
The maximum permitted diameter of the
accessories is 180 mm (7").
When working with diamond cups, use an angle
grinder with a rated input power of at least 2000W.
Do not use for abrasive cutting-off operations,
roughing work, sanding, polishing or flap disc work.
Do not machine anymetallic materials. Suitable for the
extraction of dusts generated during surface grinding of
mineral materials, wood, plastics, glassfibre-reinforced
plastics, paints and residue of adhesives.
Always use a suitable dust extraction system:
Connect an M-class vacuum cleaner to the
extractor connection piece (9). We recommend
using an antistatic suction hose Ø 35 mm.
Note: The ring brush maystick when thermoelastic
materials are processed.
The machine must not be used with water.
It is suitable for commercial use in trade and
industry.
The user bears sole responsibility for any damage
caused by inappropriate use.
Generally accepted accident prevention
regulations and the enclosed safety information
must be observed.
Dipl.-Ing. (FH) Dieter Hammel
02.01.2017, i.V..
1
3.
General Safety Instructions
For your own protection and for the protection of
your power tool, pay attention to all parts of the text
that are marked with this symbol!
WARNING – Reading the operating
instructions will reduce the risk of injury.
WARNING Read all safety warnings and
instructions. Failure to follow all safety
warnings and instructions may result in electric
shock, fire and/or serious injury.
Keep all safety instructions and information for
future reference.
Pass on your power tool only together with these
documents.
4.
Special Safety Instructions
4.1
Safety warnings common for grinding,
sanding:
Use
a) This guard is designed for surface grinding.
Read all safety warnings, instructions, illu-strations
and specifications provided with this guard.
Failure to follow all instructions listed below may result in
electric shock, fire and/or serious injury.
b) This guard is not suitable for routing,
polishing, sanding, working with roughing discs, wire
brushes, parting grinder discs or
flap discs.
Operations for which the guard was not designed may
create a hazard and cause personal injury.
c) Do not use accessories which are not specifically
designed and recommended for
this guard and the power tool by the manufacturer.
Just because the accessory can be attached to your
power tool, it does not assure safe operation.
d) The rated speed of the accessory must be at
least equal to the maximum speed marked on the
power tool.
Accessories running faster than their rated speed can
break and fly apart.
e) The outside diameter and the thickness of your
accessory must correspond to the dimensions of your
guard and your power tool.
Incorrectly sized accessories cannot be adequately
guarded or controlled.
f) Prior to each use check if parts are missing, worn,
broken, torn or damaged.
- 11 -
Publicité
Table des Matières
