Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.
Use
Always guide the machine with both hands
on the handles of the angle grinder provided.
7.1
Working close to walls
To open and close the segment (10) switch
off the machine and pull the mains plug. The
accessory must be stationary.
Only open the segment (10) by twisting when
working close to walls. For all other work, the
segment must be lowered.
The open area of the safety guard must face the
direction of the wall
8.2
Switching On and Off
Always guide the machine with both hands.
Switch on first, then guide the accessory towards
the workpiece.
Avoid inadvertent starts: always switch the tool off
when the plug is removed from
the mains socket or if there has been a power cut.
In continuous operation, the machine continues
running if it is forced out of your hands.
Therefore, always hold the machine with both
hands using the handles provided, stand securely
and concentrate.
Avoid the machine swirling up or taking in dust and
chips. After switching off the machine, only place it
down when the motor has come to a standstill.
Continuous Operation
Switch ON: Push the lock (7) in the direction of the arrow
and then press and hold the switch (8). Machine is now
switched on. Now push the lock (7) once more in the
direction of the arrow to lock the switch (8).
Switch OFF: Press and release the switch presser (8).
9.
Maintenance
It is possible that particles deposit inside the power tool
during operation. This impairs the cooling of the power
tool. Conductive build-up can impair the protective
insulation of the power tool and cause electrical hazards.
The power tool should be cleaned regularly, often and
thoroughly through all front and rear air vents using a
vacuum cleaner or by blowing in dry air.
Prior to this operation, separate the power tool from the
power source and wear protective glasses and dust mask.
Prior to each use, check if there are parts
missing, worn, broken, torn or damaged.
Do not use defective or incomplete guard.
Replace brush rim (7): replace worn brush rim for optimum
extraction. Pull out worn brush rim and fully insert new
brush rim (#082650).
10.
Troubleshooting
The electronic signal display lights up
and the load speed decreases. (14)
There is too much load on the machine! Run the
machine in idling until the electronics signal
indicator switches off.
The machine does not start. The electronic
signal display (14) (depends on model)
flashes.
The restart protection is active. If the mains plug is
inserted with the machine switched on, or if the power
supply is restored following an interruption the machine
does not start up.
Switch the machine off and on again.
11.
Accessoires
Use only genuine accessories.
Use only accessories which fulfil the requirements
and specifications listed in these operating instructions.
- 16 -
Publicité
Table des Matières
