Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CALIBRATION / PROGRAMMING
Programming
CALIBRATION / PROGRAMMING
User Interface
When power is initially applied, the unit's LCD screen will display the
product's name and firmware revision.
Programming
The 301EMRP (remote panel) actions are programmed in the 301EM
(see 301EM User Manual, Appendix section). The unit performs the
programmed actions depending on what accessories are connected to
the unit. The 301EMRP addresses must be programmed on each unit
to enable them to receive information from the 301EM. Once the
addresses are programmed, the 301EM will detect the remote panels
through network scans.
Key Definitions
ESC Key:
(Up/Down):
Enter Key:
Fan Start Key:
Silence Key:
16
Use the ESC Key to exit the menus or cancel an
input. Use it also to stop the alternating reading
between the connected sensors.
Use the Scroll Keys to scroll the menus or to select a
specific value.
Use the Enter Key to enter a programming field or to
validate a specific value.
Control relay #1 (Fan)
(For B-52 or ASHRAE 15 programming).
Turns off the buzzer and horns
301EMRP User Manual
Honeywell
511395
2/07
Publicité
Chapitres
Table des Matières
