Yamaha R-N303 Mode D'emploi page 55

■
Bluetooth
Problem
The "Bluetooth" setting in the settings
The unit cannot
menu is "Off".
connect to a
Bluetooth device.
The unit is connected to a different
Bluetooth device.
The unit is too far away from the
Bluetooth device.
A device emitting electromagnetic waves
(such as a microwave oven, a wireless
device and so on) are located nearby.
The Bluetooth device you are using does
not support the A2DP protocol.
The connection profile registered in the
Bluetooth device is not functioning
correctly for some reason.
The passkey on the Bluetooth adapter or
other device is set to a code besides
"0000".
The volume on the Bluetooth device is too
No sound can be
low.
heard, or the sound
cuts off intermittently.
The sound output on the Bluetooth device
is not set to this unit.
The connection to the Bluetooth device is
cut off.
The unit is too far away from the
Bluetooth device.
A device emitting electromagnetic waves
(such as a microwave oven, a wireless
device and so on) is located nearby.
Possible cause Remedy
Set the "Bluetooth" setting in the settings menu to
"On".
Unpair the Bluetooth device that is currently
connected, and pair with the desired Bluetooth
device.
Move the Bluetooth device closer to this unit.
Do not use this unit near devices that emit
electromagnetic waves.
Use a Bluetooth device that supports the A2DP
protocol.
Delete the connection profile in the Bluetooth device,
and then connect the Bluetooth device to this unit.
Use a Bluetooth device on which the passkey is set to
"0000".
Raise the volume on the Bluetooth device.
Select this unit as the output destination on the
Bluetooth device.
Connect with the Bluetooth device one more time.
Move the Bluetooth device near this unit.
Do not use this unit near devices that emit
electromagnetic waves.
Troubleshooting
See
page
41
30
—
—
52
30
—
—
30
30
—
—
49
En