Safety Considerations - Dustcontrol DC Tromb 400c Notice Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20

Safety Considerations

Read all instructions before attempting to operate
this machine and save these instructions.
Warning! When using electric machines, basic sa-
fety precautions should always be followed to reduce
the risk of fi re, electric shock and personal injury,
including the following:
1. Important!
No hot particles nor ignition sources are al-
lowed to be sucked into the unit. The machine
should not be used for explosives, unstable or
pyrophoric particles or dust.
– WARNING!
be adequately instructed on the use of these
machines.
– WARNING!
dry use only.
– CAUTION!
indoor use only.
– CAUTION!
be stored indoors only.
2. Work area environment
Don´t expose the machine for rain. Don´t use it
in damp or wet locations or in presence of fl am-
mable liquids or gases.
3. Overload
Never let the machine operate fully throttled.
Always follow the regulations pertinent to the
material you are working with ie asbestos. Don´t
use the machine for purposes that it isn´t inten-
ded for.
4. Body injuries
Never let the suction come in contact with parts
of the body. The strong suction effect can hurt
the blood-vessels in the skin. Do not repair the
electric components yourself. The machine
should be serviced by qualifi ed personnel only.
Faults may cause injury. See also below under
warnings.
2015-12-02
Operators shall
This machine is for
This machine is for
This machine shall
DC Tromb 400- 10
5. Don´t abuse cord
Never pull the machine by the cord. Keep the
cord from heat and sharp edges. Check the
electric cable regularly for damage.
6. Important measure
With cleaning and maintenance on the mach-
ine, the power cable should be disconnected
from the supply.
7.
Maintain the machine with care
Keep machine clean and check that the hose is
undamaged and that all gaskets are tight. Follow
instructions. Keep handles dry and free from oil
and grease.
8. Checking for damage
Before futher use of the machine it should be ca-
refully checked that the machine is un damaged.
If there are any damaged parts these should be
repaired by a Dustcontrol authorized service
center.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualifi ed persons in order to avoid a hazard.
9. Warning
Use only accessories and replacable parts which
are available in the Dustcontrol catalogue. When
using faulty parts or pirate parts (espe-cially
fi lter) the machine could leak out unhealthy dust
which can cause personal injuries.
This appliance is not intended for use by per-
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for their
safety. Children should be supervised to ensure
that they do not play with the appliance.
This machine is intended for commercial use
only, for example in hotels, schools, hospitals,
factories,shops, offi ces and rental businesses.
Part No 9480-A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dc tromb 400aDc tromb 400lDc tromb 400 série

Table des Matières