Compliance - Welch Allyn ABPM 7100 Mode D'emploi

31 - Compliance

Compliance
General radio compliance
The wireless features of this monitor must be used in strict accordance with the manufacturer's instructions
as described in the user documentation that comes with the product.
This device complies with Part 15 of the FCC rules and with the rules of the Canadian ICES-003 as
described below.
Federal Communication Commission (FCC) Interference Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
•
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.
Industry Canada (IC) emissions
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
This radio transmitter (IC ID: 5123A-BGTWT11IA) has been approved by Industry Canada to operate with
the antenna listed in the specification table.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conform à la norme NMB-003 du Canada.
European Union
I.E.M. GmbH declara que este ABPM 7100 está conforme com os requisitos essenciais e outras
disposições da Directiva 1999/5/CE.
Bluetooth®
Category Feature
Wireless specification Bluetooth
Transmit Power
Range
Coexistence 802.11
Antenna Internal, chip antenna
Environmental
Operating Temperature
Approvals Bluetooth
FCC / IC / CE / MIC / KC
This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU member
states and EFTA countries, except in France and Italy where restrictive use applies.
In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain
authorization to use the device for setting up outdoor radio links and/or for supplying public access to
telecommunications and/or network services.
This device may not be used for setting up outdoor radio links in France and in some areas the RF output
power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz.
For detailed information the end-user should contact the national spectrum authority in France.
Norway — Do not operate the ABPM 7100 Bluetooth function in the geographical area within a radius of 20
km from the center of Ny-Ålesund.
United Arab Emirates
TRA
REGISTERED No:
ER40002/15
DEALER No:
DA44647/15
Compliance - 32
Implementation
v2.1 / v.2.1 + EDR
Class 1, +12 dBm
100 meters line-of-sight
IEEE 802.11
Max. gain 0.5dBi
-40C to +85C
Registered
Approved