Machine Adjustment Procedures; Centering The Abrasive Belt; Adjusting Sanding Pressure - Kunzle & Tasin Bona Belt Lite Manuel D'utilisation

Machine Adjustment Procedures

Centering the abrasive belt

The belt centers automatically on starting the motor.
When first fitted the belt may be in the wrong position.
In this case use the spanner (A) and proceed as follows:
Stand beside of the machine to check that following operation the belt is positioned correctly.

Adjusting sanding pressure

To vary drum pressure on the floor, use the adjustment knob and proceed as follows:
1.
Turn the adjustment knob (A)
clockwise to decrease drum
pressure on the floor.
The belt is positioned correctly when:
It runs along the inside of the tensioning unit (A).
It protrudes approximately 2mm from the sanding drum (B).
Turn clockwise to move the
belt towards the outside
2.
Turn the adjustment knob (A)
counter-clockwise to increase
drum pressure on the floor.
Bona Belt Lite Manual
Turn counter-clockwise to
move the belt towards the
inside
EN
23