Starting The Machine - Kunzle & Tasin Bona Belt Lite Manuel D'utilisation

Starting the Machine

To start the machine proceed as follows:
1.
Become familiar with
the machine and read all
instructions & safety notices.
Ensure that all operators read
this manual.
5.
Open the side guard (A).
20 20
2.
Arrange the dust bag as
shown and secure it with the
cord. If using DCS, connect
the adaptor supplied with
the machine and DCS hose
directly.
6.
Lower the tensioning unit
using the drum tensioning
lever (A).
3.
Locate the power supply. The
socket must be compatible
with the plug. To avoid
electrical hazards the socket
must be grounded with a
20 Amp fuse.
7.
Insert the abrasive belt,
ensuring it protrudes
approximately 2mm from
the rubber drum area but
runs along the inside of the
tensioning unit.
Bona Belt Lite Manual
4.
Wind the cable around the
cable safety arm (A) to keep
it away from the path of the
machine.