Spark Plug - Husqvarna 6751P Manuel De L'opérateur

Masquer les pouces Voir aussi pour 6751P:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TO CHANGE ENGINE OIL (See Fig. 12)
NOTE: Before tipping lawn mower to drain oil, empty fuel
tank by running engine until fuel tank is empty.
1. Disconnect spark plug wire from spark plug and place
wire where it cannot come in contact with plug.
2. Remove engine oil cap; lay aside on a clean surface.
3. Tip lawn mower on its side as shown and drain oil into
a suitable container. Rock lawn mower back and forth
to remove any oil trapped inside of engine.
CONTAINER
4. Wipe off any spilled oil from lawn mower or side of
engine.
5. Slowly pour oil down the oil fi ll spout, stopping every
few ounces to check the oil level with the dipstick.
6. Stop adding oil when you reach the FULL mark on the
dipstick. Wait a minute to allow oil to settle.
7. Continue adding small amounts of oil, rechecking the
dipstick until oil level settles at FULL. DO NOT overfi ll,
or engine will smoke heavily from the muffl er on startup.
8. Always be sure to retighten oil dipstick before starting
engine.
9. Re con nect spark plug wire to spark plug.
AIR FILTER (See Fig. 13)
Your engine will not run properly and may be damaged by
using a dirty air fi lter. Replace the air fi lter cartridge every
100 hours of op er a tion or every season, which ev er occurs
fi rst. Service air cleaner more often under dusty conditions.
TO CLEAN AIR FILTER
1. Loosen screw and tilt cover to re move.
2. Carefully remove cartridge.
3. Clean by gently tapping on a fl at surface. If very dirty,
replace car tridge.
CAUTION: Pe tro leum solvents, such as
ker o sene, are not to be used to clean
car tridge. They may cause de te ri o ra tion
of the cartridge. Do not oil car tridge.
Do not use pres sur ized air to clean or
dry car tridge.
4. Install cartridge, then replace cover making sure the
tabs are aligned with the slots in the back plate. Fasten
screw securely.
MAINTENANCE
FIG. 12
LIP
CARTRIDGE
MUFFLER
Inspect and replace corroded muffl er as it could create a
fi re hazard and/or damage.

SPARK PLUG

Replace spark plug at the beginning of each mowing season
or after every 100 hours of operation, whichever occurs
fi rst. Spark plug type and gap setting are shown in the
"PROD UCT SPEC I FI CA TIONS" section of this manual.
IN-LINE FUEL FILTER (See Fig. 14)
The fuel fi lter should be replaced once each season. If fuel
fi lter becomes clogged, ob struct ing fuel fl ow to car bu re tor,
re place ment is re quired.
1. With engine cool, remove fi lter and plug fuel line sec-
tions.
2. Place new fuel fi lter in position in fuel line with arrow
pointing towards carburetor.
3. Be sure there are no fuel line leaks and clamps are
properly positioned.
4. Immediately wipe up any spilled gasoline.
CLAMP
FUEL
FILTER
CLEANING
IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER
HOUSING FREE OF BUILT-UP GRASS AND TRASH. CLEAN
THE UNDERSIDE OF YOUR MOWER AFTER EACH USE.
CAUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with plug.
12
BACK PLATE
COVER
COVER
FIG. 13
CLAMP
FIG. 14
SLOT
TAB

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

961330022

Table des Matières