Adjusting The Height Of The Headrest - Babyauto yodafix 123 Notice D'instruction

installing the Top Tether
1. Take the Top Tether. Lengthen the strap if necessary by
pressing the Top Tether brake button
2. Attach the Top Tether hook to the Top Tether anchorage point
which is recommended in the owner's manual for your car (fig.
3.6).
Look for this symbol
in your vehicle.
3. To tighten the Top Tether, remove any slack by pulling on the
free end of the strap until it is suitably tightened. The Top
Tether will be properly tightened when the tension indicator
turns completely green (fig. 3.7).
4. fasteninG tHe cHild into tHe seat Group 1.
1. Loosen the harness straps by stretching the chest section while
holding down the harness adjustment button
2. Open the buckle (fig. 4.1 and 4.2)
3. Place the child into the seat.
4. Fit the safety harness around the child and connect the 2 parts
of the fastener, inserting them into the buckle until you hear a
click (fig. 4.3) which indicates that it is securely locked.
5. Stretch the harness adjustment belt
harness the correct amount of tension. Remember that
harnesses must be well-tightened in order to guarantee the
child's safety (4.4).

5. adjustinG tHe HeiGHt of tHe Headrest

The correct adjustment of the headrest ensures that the child
is properly fastened into the car seat. The headrest must be
18
(G)
to release the strap.
(E)
.
(F)
in order to give the