Change Door Direction - Create Fridge Studio Combi 231 Manuel D'utilisation

Table des Matières

Les langues disponibles

If the appliance is placed face up or on its side during this process, it must be left upright for at

least 24 hours before plugging in to prevent damage to internal components.

1. Remove the screw hole cover from the top left of the refrig-

erator, then remove the top cover and top hinge from the top

right of the refrigerator, and then remove the refrigerator

door from the refrigerator.

2. Remove the center hinge from the right side of the refriger-

ator, remove the screw hole covers from the left side of the

refrigerator, and remove the freezer door.

3. Remove the bottom hinge from the bottom right of the refrig-

erator.

4. Pull the pin shaft out to the right hole of the lower hinge, then

insert the pin shaft into the left hole of the lower hinge.

5. Install the bottom hinge on the bottom left side of the refrig-

erator.

6. Remove the freezer door stop from the bottom right to the

left side of the door. Remove the refrigerator door stop from

the bottom right side to the left side of the door.

7. Move the door bushing from the top right of the refrigerator

door and remove the hinge hole cover from the top left of the

door. Swap these positions.

8. Install the freezer door onto the refrigerator, position the

center hinge on the left side of the cabinet, and then install

the screw hole covers on the top right side of the refrigerator.

9. Install the refrigerator door on the refrigerator, place the top

hinge on the top left of the refrigerator, and install the screw

hole cover on the top right of the refrigerator.

Note: These instructions refer to models that come from the

factory with the door positioned on the right. If your appliance

comes with the door on the left, be sure to reverse the "left" and

"right" in these instructions.

In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substanc-

es in electric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin

shown on the package indicates that the product at the end of its service life shall be collected as separate

waste. Therefore, any products that have reached the end of their useful life must be given to waste disposal

centres specialising in separate collection of waste electrical and electronic equipment, or given back to the re-

tailer at the time of purchasing new similar equipment, on a one for one basis. The adequate separate collection

for the subsequent start-up of the equipment sent to be recycled, treated and disposed of in an environmentally

compatible way contributes to preventing possible negative effects on the environment and health and optimis-

es the recycling and reuse of components making up the apparatus. Abusive disposal of the product by the user

involves application of the administrative sanctions according to the laws.