Dremel 8150 Instructions D’utilisation Et De Sécurité page 22

EZ Lock™ Mandrel EZ402 has a spring load-
ed sleeve and is used with cutting wheels,
abrasive buffs and polishing cloth.
Always be sure the tool
is turned "OFF" and in
the Disabling mode before changing acces-
sories, changing collets or servicing your
cordless rotary tool. Such preventative safe-
ty measures reduce the risk of starting the
power tool accidentally.
Always make sure accessory is properly
seated on mandrel before use. Incorrect
seating of accessory on mandrel may lead to
personal injury or property damage.
To load accessory:
1. Place EZ Lock™ mandrel into collet as
deep as possible and tighten collet nut.
Note: There is a blue spacer that will
bottom out on the collet nut, setting the
mandrel to the correct depth. When using
with Dremel chuck, back the mandrel out
slightly before tightening.
2. Pull spring-loaded sleeve DOWN towards
tool with one hand and hold. You can
brace the tool on the body or work-bench
for extra leverage (Fig. 15).
3. With the other hand, align bowtie shape
on cut-off wheel with mandrel and make
sure metal insert is facing away from the
tool (Fig. 16).
4. Place wheel on the mandrel to a point
just below the bowtie on the mandrel and
twist 90 degrees until the bowtie shape on
the wheel aligns with the sleeve. Release
sleeve. Wheel should lock in place (Fig. 17).
5. When mounting sanding and polishing ac-
cessories, align bowtie with metal insert
on bottom of accessory (Fig. 18 & 19).
To check for proper seating, hold shaft lock
button and twist accessory. Accessory will
not be able to rotate on mandrel.
To unload accessory:
1. Pull spring-loaded sleeve DOWN toward
tool with one hand (Fig. 15).
2. Hold sleeve down while twisting acces-
sory 90 degrees.
3. Remove accessory.
During use
Avoid damage to EZ lock™ mandrel by not let-
ting it contact the workpiece.
22
1605A0035J 8150 202502.indd 22 1605A0035J 8150 202502.indd 22
EZ Lock™ Operating Instructions page heading
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
2/27/2025 4:28:38 PM 2/27/2025 4:28:38 PM