On/Off Button - Dremel 8150 Instructions D’utilisation Et De Sécurité

Whenever you hold the tool, be careful not to cover the air vents with
your hand. This blocks the air flow and causes the motor to overheat.

On/Off Button

(Fig. 6)
The tool is switched "ON" by the On/Off But-
ton 1 located on the topside of the motor
housing.
TO TURN THE TOOL "ON," press and release
the On/Off Button 1.
TO TURN THE TOOL "OFF," press and release
the On/Off Button 1.
Note: The tool cannot be turned on while in
the disabling mode.
Variable Speed Dial
(Fig. 6)
Your tool is equipped with a Variable Speed
Dial 9. The speed may be adjusted during
operation by rotating the dial back or forth
between any one of the settings.
Switch Approximate Speed,
Setting
0 Off (Disabling Mode)
5
10*
15
20
25
30
* Wire Brush Setting.
You can refer to the charts on pages 24-27
to determine the proper speed, based on the
material being worked and the type of acces-
sory being used. These charts enable you to
select both the correct accessory and the op-
timum speed at a glance.
16
1605A0035J 8150 202502.indd 16 1605A0035J 8150 202502.indd 16
page heading Operation
/min (RPM)
3,500 – 6,500
7,000 – 13,000
13,500 – 17,000
18,500 – 22,500
22,500 – 25,000
25,500 – 30,000
Fig. 6
10
1
9
Disabling Mode
(Fig. 6)
In the disabling mode, the rotary tool is off
and cannot be turned on.
Turning the Variable Speed Dial 9 to 0 will
activate the disabling mode, turn the tool off,
and prevent the tool from turning on. There
will be a click when the Variable Speed Dial 9
enters or exits the disabling mode.
2/27/2025 4:28:35 PM 2/27/2025 4:28:35 PM