Battery Charge Indicator - Dremel 8150 Instructions D’utilisation Et De Sécurité

Learn the LED Behavior
(Fig. 6)
Flashing LEDs on the Battery Charge Indicator 10 serve as error messages.
Error Code Description of
Visual Error Code
Right light
flashing
Left light
flashing
All three lights
flashing
Built In Work Light
(Fig. 1)
Your tool is also equipped with a work light
on the Nose Cap 4 that turns on automati-
cally when the switch is activated. When the
tool is turned off, the light turns off.
To dim or disable the work light, press and
hold the On/Off Button 1 for up to 3 seconds
while turning ON the tool. Release the On/Off
Button 1 when the light reaches the desired
brightness or continue to hold until the light
has dimmed completely. The tool will turn off
if the On/Off Button 1 is held for 6 seconds
or longer.
To reset the work light, turn the tool OFF and
repeat the instructions to dim or disable.

Battery Charge Indicator

(Fig. 6)
This tool is equipped with a Battery Charge
Indicator 10 that tells you how much charge
your battery has.
A fully charged battery is indicated when all
three LED lights are illuminated. As the bat-
tery discharges, the lights will turn off one by
one until only one light is on. When the last
light starts "flashing", the battery is almost
empty.
When the battery is dead, the tool will auto-
matically turn off. This will be a sudden stop
as opposed to a gradual winding down of the
tool. Simply recharge the tool.
1605A0035J 8150 202502.indd 17 1605A0035J 8150 202502.indd 17
page heading Operation
Meaning
Excessive tool or battery temperature.
Battery is under-voltage; battery charge is too low to
start the tool; battery cannot be charged.
Battery current is too high; the On/Off Button 1 was
pressed while the charging cable is connected or while
the Variable Speed Dial 9 is set to disabling mode.
State of LEDs
Charging the Tool
(Fig. 1)
ed by Dremel. Use of other USB cables may
result in tool and property damage and per-
sonal injury.
The Dremel 8150 is designed to charge with
any 5V USB power adapter certified and
marked by an independent safety testing lab-
oratory such as UL, CSA, or Intertek (ETL).
Always use the provided USB-C Charging
Cable 13 to charge the rotary tool.
Your Dremel 8150 does not come completely
charged from the factory. Be sure to charge
the tool prior to initial use.
To charge:
1. Insert the USB-C Charging Cable 13 into
the USB port of the power adapter (not
included).
Battery
Status
3 x solid LEDs 75% - 100%
2 x solid LEDs 40% - 75%
1 x solid LED 15% - 40%
1 x blinking
<15%
LED
Charge the Dremel 8150
with a USB cable provid-
2/27/2025 4:28:36 PM 2/27/2025 4:28:36 PM
17