Accessories - Wagner Vector Pro Manuel Du Propriétaire

9. Install the seal assembly into the front of
the gun head.
10. Replace the retractor plate (4) inside
the rear of the gun head. Make sure
the flats just above the threads on the
seal assembly are horizontal so it slides
through the hole in the retractor plate.
11. Using a 3/8" socket, tighten the lock
nut onto the end of the seal assembly.
Torque to 5 Nm (3.7 ft. - lbs.).
12. With the trigger depressed, install the
diffuser into the front of the gun head
and tighten securely with a wrench.
13. Replace the rear housing.
Replacing/Removing the Filter
i
The gun filter should be cleaned
after every use.
1. Unclip the top of the trigger guard from
the gun head.
2. Using the bottom of the trigger guard as
a wrench, loosen and remove the handle
assembly from the gun head.
3. Pull the old filter out of the gun head.
Clean or replace.
4. Slide the new filter, tapered end first, into
the gun head.
5. Thread the handle assembly into the gun
head. Tighten with the trigger wrench.
6. Snap the trigger guard back onto the gun
head.
Vector Pro
Filter Chart
Part Application
Number
0034383 Synthetic resin,
enamels, clean
varnishes, stains,
azures
0043235 Base coat enamels,
primer enamels,
fillers, marking
paints, textured
enamels
0034377 Emulsions, latex
paints, acrylic paints
0089323 Filler paints, large
area surfaces

Accessories

i
In order to use any accessories
with an F-thread (11/16")
an adapter (P/N 0553300) is
required.
Filter Filter
Type Color
Extra- Red
fine
Fine Yellow
Medium White
Coarse Green
15
GB