Preparing The Remote Control; Using The Remote Control; Replacing The Battery In The Remote Control - Yamaha CRX-330 Mode D'emploi

CONTROLS AND FUNCTIONS

■ Preparing the remote control

The remote control comes with the battery already
installed. Before using the remote control for the very first
time, pull out the insulation sheet, as shown.
y
Remove the transparent sheet before using the remote control.

■ Replacing the battery in the remote control

Change the battery when the operation range of the remote control decreases.
Use a straight pin to
remove the cover.
Notes
• Insert the battery according to the polarity markings (+ and -).
• If the battery runs out, immediately remove it from the remote control to prevent an explosion or acid leak.
• If the battery starts leaking, dispose of it immediately. Be careful not to let the leaking battery acid touch your skin or clothing.
• Before inserting a new battery, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.
8
En

■ Using the remote control

Use the remote control within 6 m (20 feet) of the
component you want to control and point it toward its
remote control sensor (see page 3).
Insulation sheet
Notes
• Be careful not to spill liquid on the remote control.
• Be careful not to drop the remote control.
• Do not leave the remote control in the following places:
– hot or humid places, such as near a heater or in a bathroom
– extremely cold places
– dusty places
Replace the battery
with a new CR2025 battery.
VOLUME
STANDBY ON
PHONES
Within 6 m
(20 feet)
30˚ 30˚
STANDBY ON
SLEEP
CD iPod FM USB
PRESET FM
TUNING MEMORY
FUNCTION
MENU
DISPLAY
FOLDER
SHUFFLE REPEAT
MUTE VOLUME
Close the cover.
INPUT