Rotary SPM32-E Mode D'emploi page 80

INDEX
Electronic board configuration
Control box part no. 047303030-047303230
After replacing the electronic board it is necessary to configure it following the instructions below:
- configure the board with the lift carriages completely lowered (lower limit switches triggered).
- set to ;
- remove the cover of the electric box;
- check that the lever (3) is set to (A) (in manual);
- position the switches (4) as shown in the figure;
- simultaneously press the push-buttons P1 and P2 and set to
- after about 5 sec. the LED (2) of the board will flash once.
- the supply of the buzzer will switch from continuous to discontinuous (2s ON and 2s OFF).
- set the lever (3) to (B) (in automatic) (buzzer OFF).
047303230
047303030
EN_32 0474-M005-0
4 P2 B 3 A
;
P1 2
1
SPM32-E | SPM32-C