A&D Medical PRECISION CHECK PRO Manuel D'instructions page 30

Taking Your Blood Pressure
1. Press the
1 to 4.
2. Press the START/STOP button. All of the
display segments are displayed. If interval is
ON, then rest for the displayed count. Zero
(0) is displayed blinking briefly. The display
changes, as indicated in the figure at the right,
as the measurement begins. The cuff starts to
inflate. It is normal for the cuff to feel very tight.
A pressure bar indicator is displayed, on the
left edge of the display, during the inflation.
Note: If you wish to stop inflation at any time, press the
START/STOP button again
3. W hen inflation is complete, deflation starts
automatically and
measurement is in progress. Once the pulse is
detected, the mark blinks with each pulse beat.
Note: If an appropriate pressure is not obtained, the monitor
starts to inflate again automatically. To avoid re-inflation, see
"Measurement with desired Systolic Pressure".
4. T he display measurement is complete, the
systolic and diastolic pressure readings
and pulse rate are displayed. Clock display
automatically switches between date, time,
and temperature. The cuff exhausts the
remaining air and deflates completely.
5. Press the START/STOP button to turn the
monitor off. After one minute of non-operation,
the monitor will turn off automatically.
6. The reading is then stored into memory.
See "Reviewing memory" for more information.
E-30
button to select a user from
blinks, indicating that the
At heart level
Press
All of the display
segments displayed
Resting Mode ON
The set
resting time
is displayed.
Resting
Mode
After rest time
OFF
Zero display
Starts inflation
Pressurizing
Measurement in progress
Systolic pressure
Diastolic pressure
AHA classification
Pulse rate
Exhausts remaining air automatically
BLE mark blinks
when communicating
(transferring the data)
Turn off and store data with
the START/STOP button