Connecting The Power Cord; Connecting The Interface Cable (For Automatic Mode) - Dentsply Sirona inLab MC X5 Notice D'utilisation

4 Transportation and installation
4.4 Connecting the suction device
16
4.4.2

Connecting the power cord

NOTICE
Grounded power outlet
The unit must be connected to a grounded power outlet.
1. Insert the power cable into the relevant socket on the suction system.
2. Plug the other end into an appropriate power socket with a protective
ground terminal.
Note on the power cable:
The suction system must only be operated with a power cable with a plug
system designed for the relevant country.
Check the voltage specification on the rating plate. The system must
conform to the country-specific supply voltage.
4.4.3

Connecting the interface cable (for automatic mode)

1. Plug the 9-pole connector into the socket of the suction device.
2. Plug the 15-pole connector into the socket of the processing
machine.
Operating Instructions Suction devices for inLab MC X5 and
Dentsply Sirona
64 98 609 D3608
D3608.201.02.04.02 09.2017