l)
Do not use sharp and/or metal objects for cleaning (e.g., a wire brush or a metal spatula)
because they may damage the surface material of the appliance.
m) Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel,
oils or other chemical substances because it may damage the device.
4.4.2.
Plate maintenance
Protect the plate by covering it with salt-free cooking oil, using a kitchen roll or a cloth.
Leave the plate for one hour and then wipe away the remaining oil with a cloth. The grill
plate prepared in the described way can be used again for grilling.
4.4.3.
Cleaning instructions
After each use, the grill must be thoroughly cleaned:
In case of a one-time, short use, simply wipe the grill with a paper towel.
After a prolonged period of use, you can use a special grill scraper (and/or a sponge or a
brush) to collect the remaining food and remove it to the drain area. After the remaining
food is removed, dry the grill plate surface with a clean kitchen roll and treat the surface as
described above.
IMPORTANT: Be careful to keep the scraper at an angle to the surface of the grill. Do not
scrape too deep as it may leave scratches on the surface of the grill, which will make food
stick to the surface.
If the surface is very dirty, it can be washed with water and detergent.
IMPORTANT: Please note that detergents remove the natural oil film from the surface, so
the grill must be coated with oil after washing.
After each use, remove and clean the collection drawer. The container must be washed with
detergent.
IMPORTANT: If the container is not cleaned, the remaining food and fats may ignite when
the grill is heated again.
IMPORTANT: Do not pour water over hot grill plates. It may cause deformation and cracks in
the heating plate, i.e., permanent damage.
4.4.4. Disposing of used devices
Do not dispose of this device in municipal waste systems. Hand it over to an electric and
electrical device recycling and collection point. Check the symbol on the product, instruction
manual and packaging. The plastics used to construct the device can be recycled in accordance
with their markings. By choosing to recycle you are making a significant contribution to the
protection of our environment.
Contact local authorities for information on your local recycling facility.
4.5.
Parts list
EN
Figure 3: Spare parts of model