Safety In The Workplace - Royal Catering Rcg-60Gb Manuel D'utilisation

e) If working with the device outdoors, make sure to use an extension cord suitable for
outdoor use. Using an extension cord suitable for outdoor use reduces the risk of electric
shock.
f) If using the device in a damp environment cannot be avoided, a residual current device
(RCD) should be applied. The use of an RCD reduces the risk of electric shock.
g) Do not use the device if the power cord is damaged or shows obvious signs of wear. A
damaged power cord should be replaced by a qualified electrician or the manufacturer's
service centre.
h) To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do
not use the device on wet surfaces.
i) ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in water or other
liquids.
j) Do not use in very humid environments or in the direct vicinity of water tanks.
k) Prevent the device from getting wet. Risk of electric shock!
3.2.

Safety in the workplace

a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to
accidents. Try to think ahead, observe what is going on and use common sense when
working with the device.
b) Do not use the device in a potentially explosive environment, for example in the presence of
flammable liquids, gases or dust. The device generates sparks which may ignite dust or
fumes.
c) If you discover damage or irregular operation, immediately switch the device off and report
it to a supervisor without delay.
d) If you are unsure about whether the device is operating correctly or if you find damage,
please contact the manufacturer's service centre.
e) Only the manufacturer's service centre may make repairs to the device. Do not attempt to
make repairs yourself!
f) In case of fire, use a powder or carbon dioxide (CO
on live electrical devices) to put it out.
g) Children or unauthorised persons are forbidden to enter a work station. A distraction may
result in loss of control over the device.
h) Use the device in a well-ventilated space.
i) Regularly inspect the condition of the safety labels. If the labels are illegible, they must be
replaced.
j) Please keep this manual available for future reference. If this device is passed on to a third
party, the manual must be passed on with it.
EN
) fire extinguisher (one intended for use
2