Ruby Fires Mystic Fire RF50 Mode D'emploi page 25

Troubleshooting
Symptom
Reason
The flame effect does The power plug is not inserted into the wall
socket.
not start.
Low water
Low voltage plug is not connected well
(see Figure 6).
The transductor (mist maker) is not correctly
installed in the receptacle.
The flame effect is too
The control
low. low (see Figure 2).
The metal disk in the transductor may be dirty
(see Figure 12).
The cable of the transductor (mist maker) runs
over
Unpleasant smell when
Dirty or stale water
the fire is used
Using unfiltered tap water
The flame effect
The flame effect is set too high.
produces too much
smoke.
The main lamps do not No water in the water reservoir
work and there are no
flames or smoke.
level
knob of the flame effect is set too
the metal disk.
20
Solution
Check whether the plug is properly inserted into
the wall socket.
Check whether the water reservoir
whether water is in the receptacle.
Checkwhether the low voltage plug is properly
connected. (Figure 6)
Checkwhether the transductor is properly and
entirely in the hole.
Slowly turn the control knob 'D' clockwise to
increasethe flame intensity (seeFigure2).
Clean the metal disk with the supplied soft
brush (see Figure 12and 'Maintenance' for a
step-by-step procedure).
Place the cable correctly and let it run outwards
via the hole at the back of the receptacle.
Clean the fire as described in 'Maintenance'.
Only use water with a hardness of maximum
1OdH or use demineralised or reverse osmosis
water.
Turn the control knob 'C' of the flame effect
clockwise (approx. a quarter turn each time).
Give the flame mechanism some time to
respond to the new setting (seeFigure2).
Follow the instructions described
Maintenance 'Filling the water reservoir'.
Checkwhether the plug is properly insertedinto
the wall socket.
Switch'A'(Figure2) is in the ON( I ) position.
is full and
in