Installation; Unpack The Machine; Operation; Start The Machine - GreenWorks HTE321 Manuel D'utilisation

8

INSTALLATION

8.1

UNPACK THE MACHINE

WARNING
It is not necessary to assemble the machine.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove the machine from the box.
4. Discard the box and package in compliance with
local regulations.
8.1.1 INSTALL THE BATTERY PACK
Figure 2
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.1.2 REMOVE THE BATTERY PACK
Figure 2
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9

OPERATION

• Do not put your fingers into the notches or in
position where they can get cut.
• Do not touch the blade unless you remove the
battery pack.
• Do not use the machine if the blade is damaged or
bent.
• Remove all objects such as cords, lights, wire, or
string which can become entangled in the cutting
blade and create a risk of personal injury.
English
If the blade jams on an electrical cord or line, DO NOT
TOUCH THE BLADE! IT CAN BE LIVE AND
DANGEROUS. Do the steps below:
1. Hold the insulated rear handle or put the machine
down and away from you.
2. Disconnect the electrically service to the damaged
line or cord before you try to free the blade.
9.1

START THE MACHINE

Figure 3.
1. Press the safety lock button.
2. Press the trigger while you hold the safety lock
button.
3. Release the safety lock button.
Hold the machine with hands during operation.
If the machine accidentally falls, it will stop and the
blade will fully stop after a few seconds. The machine
will then lock OFF.
9.2

STOP THE MACHINE

Figure 3.
1. Release the trigger to stop the machine.
9.3

TURN THE REAR HANDLE

Figure 4.
You can use the rotating button to adjust the rear
handle to 5 different positions to cut the hedges easier.
1. Put the machine on a flat and smooth surface.
2. Pull the rotating button and turn the rear handle.
3. Release the rotating button until it locks into
position.
10

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
7
WARNING
WARNING
NOTE
CAUTION
CAUTION
EN