Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
Wear eye protection.
2.
Always use guards and eye shields.
3.
Use only wheels having a maximum operating
speed at least as high as "No Load RPM"
marked on the tool's nameplate.
4.
Check the wheel carefully for cracks or
damage before operation. Replace cracked or
damaged wheel immediately.
5.
Secure the wheel carefully.
6.
Be careful not to damage the spindle or the
bolt, or the wheel itself might break.
7.
Keep a space of 5 mm (3/16") between the
sharpening platform guide (rail) and the
grinding wheel.
8.
Keep hands away from rotating parts.
9.
Make sure the workpiece is not contacting the
wheel before the switch is turned on.
10. Before using the tool on an actual workpiece,
let it run for several minutes. Watch for flutter
that might be caused by incorrect installation
or a poorly balanced wheel.
11.
Use the upper surface of the wheel only. Do
not use the side surface.
12. If the wheel stops during operation, makes an
odd noise or begins to vibrate, switch off the
tool immediately.
13. Always switch off and wait for the wheel to
come to a complete stop before adjustment or
inspection.
14. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
15. Dry the wheel by idling the tool after operation
to prevent the wheel from freezing in cold
weather. Freezing can crack the wheel.
16. Store wheels in a dry location only.
17. Do not overtighten wheel nut.
18. Use only flanges furnished with this tool.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the tool is switched off.
007285
To start the tool, press the "ON" side of the switch
located on the front of the tool. To stop the tool, press the
"OFF" side of the switch.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Replacing grinding wheel
Use the wrench provided to release the grinding wheel
by turning the installation screw counterclockwise.
2
3
007270
To install the grinding wheel, follow the removal
procedure in reverse.
Adjusting wheel guard
The top of the wheel guard should be 1 mm (approx.
3/64") below the surface of the grinding wheel. Adjust
height by turning the guard clockwise to lower it, or
counterclockwise to raise it.
4
1. Switch
1
1. Wrench
2. Grinding wheel
installation
1
screw
3. Wheel
Publicité
Table des Matières
