Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
SPECIFICATIONS
No load speed (RPM)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
For Your Own Safety Read
Instruction Manual
Before Operating Tool
Save it for future reference
GENERAL SAFETY
PRECAUTIONS
(For All Tools)
1.
KNOW YOUR POWER TOOL. Read the owner's
manual carefully. Learn the tool's applications
and limitations, as well as the specific
potential hazards peculiar to it.
2.
KEEP GUARDS IN PLACE and in working
order.
3.
REMOVE ADJUSTING KEYS AND WRENCHES.
Form habit of checking to see that keys and
adjusting wrenches are removed from tool
before turning it on.
4.
KEEP WORK AREA CLEAN. Cluttered areas
and benches invite accidents.
5.
DO NOT USE IN DANGEROUS ENVIRONMENT.
Do not use power tools in damp or wet
locations, or expose them to rain. Keep work
area well lighted. Do not use tool in presence
of flammable liquids or gases.
6.
KEEP CHILDREN AWAY. All visitors should be
kept safe distance from work area.
7.
MAKE WORKSHOP KID PROOF with padlocks,
master switches, or by removing starter keys.
8.
DO NOT FORCE TOOL. It will do the job better
and safer at the rate for which it was designed.
9.
USE RIGHT TOOL. Do not force tool or
attachment to do a job for which it was not
designed.
Model
Wheel size
Overall length
Net weight
200 mm x 25 mm x 75 mm (7-7/8" x 1" x 3")
USA016-2
10. WEAR PROPER APPAREL. Do not wear loose
clothing, gloves, neckties, rings, bracelets, or
other jewelry which may get caught in moving
parts. Nonslip footwear is recommended.
Wear protective hair covering to contain long
hair.
11.
ALWAYS USE SAFETY GLASSES. Also use
face or dust mask if cutting operation is dusty.
Everyday
resistant lenses, they are NOT safety glasses.
12. SECURE WORK. Use clamps or a vise to hold
work when practical. It's safer than using your
hand and it frees both hands to operate tool.
13. DO NOT OVERREACH. Keep proper footing
and balance at all times.
14. MAINTAIN TOOLS WITH CARE. Keep tools
sharp
performance.
lubricating and changing accessories.
15. DISCONNECT TOOLS before servicing; when
changing accessories such as blades, bits,
cutters, and the like.
16. REDUCE THE RISK OF UNINTENTIONAL
STARTING. Make sure switch is in off position
before plugging in.
17. USE
Consult the owner's manual for recommended
accessories. The use of improper accessories
may cause risk of injury to persons.
18. NEVER STAND ON TOOL. Serious injury could
occur if the tool is tipped or if the cutting tool
is unintentionally contacted.
19. CHECK DAMAGED PARTS. Before further use
of the tool, a guard or other part that is
damaged should be carefully checked to
determine that it will operate properly and
perform its intended function - check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any
other conditions that may affect its operation.
A guard or other part that is damaged should
be properly repaired or replaced.
2
9820-2
560 /min.
390 mm (15-3/8")
11 kg (24.3 lbs)
eyeglasses
only
and
clean
for
best
Follow
instructions
RECOMMENDED
have
impact
and
safest
for
ACCESSORIES.
Publicité
Table des Matières
