Troubleshooting Guide; Ordering Replacement Parts - Ninja BL450 Manuel Du Propriétaire

Troubleshooting Guide

PROBLEMS
Motor doesn't start or
attachment doesn't rotate.
Food is unevenly chopped.
Food is too finely chopped or too
watery.
Cup is leaking.
Unit doesn't turn on.
Unit doesn't turn off.
Doesn't mix well.
Lid/blade assembly will not
properly align to the cup.
Replacement Parts

ORDERING REPLACEMENT PARTS

To order additional parts and attachments, please visit our website: www.ninjakitchen.com or feel free to contact customer
service: 1-877-646-5288.
16 1-877-646-5288
POSSIBLE REASONS & SOLUTIONS
For the cups, make sure that the tabs are seated in the slots and turned
clockwise.
Either you are chopping too much food at once, or you are not pulsing properly.
Reduce the amount of food in the cup.
The food has been over processed. Use short pulses for best results. Press down
on the cup in short intervals.
Make sure that your lid or blade assembly is properly assembled to the cup.
Leaking may occur if it is misaligned when twisted onto the cup. Turn the lid
tightly clockwise.
Make sure the unit is plugged in.
Rotate and press down on the cup to turn the unit on.
Make sure the blade assembly is properly assembled to the cup and that it is
not misaligned.
Unplug the power cord from the electrical outlet and call customer service for
support.
Pulse ingredients for best results. Press down on the cup in short intervals for
even blending and chopping. For frozen ingredients, pulse in short intervals of
2-5 seconds and repeat.
Set the cup on a level surface. Place the lid or blade assembly on top of the cup
and align the threads so that the lid/blades sit flat on the cup. Twist clockwise so
that the lid/blades evenly align to the cup until you have a tight seal.