Ninja BL450 Manuel Du Propriétaire page 13

Use
WARNING: Never leave the appliance unattended while in use.
CAUTION: Handle the blade assembly with care, as the blades are very sharp.
CAUTION: DO NOT BLEND HOT LIQUIDS.
CAUTION: Do not use stainless steel cup accessory model XSKDWSS24 with blender.
IMPORTANT: Make sure that the motor base is plugged in for use
ASSEMBLY
Fig. 1 Fig. 2
1 Place the motor base on a clean, dry, level surface such
as a counter or table top.
2 Add ingredients to the cup.
3
Place the blade onto the cup and twist it on tightly until
you have a good seal. (Fig. 1)
4
Turn the cup upside down and place it onto the motor
base, aligning the tabs on the cup with the motor base.
Turn it clockwise, the unit is ready for use.(Fig. 2)
5
Press down on the top of the cup in short intervals to
activate. (Fig. 3)
6
When you have reached your desired consistency,
stop the appliance by removing your hand from the
cup. Wait for the motor to stop running. Then turn the
cup counterclockwise (Fig. 4) and pull straight up to
remove. (Fig. 5)
PULSE
Fig. 3
For best results, use short "PULSES"!
NOTE: Do not overfill! To avoid spilling, do not add
ingredients past the "Max" fill line.
7 Turn the cup upright and remove the Blade Assembly by
twisting the blade assembly counterclockwise. Be sure
to store the Blade Assembly attached to an empty cup
when not in use.
8
Place the Sip & Seal
enjoy!
9
Make sure that the motor base is unplugged when not
in use.
REMOVAL
Fig. 4
lid onto the cup, twist to seal and
®
www.ninjakitchen.com
Fig. 5
13