Troubleshooting Guide; Replacement Parts; Ordering Replacement Parts - Ninja BL450 Mode D'emploi

Troubleshooting Guide

PROBLEMS
Motor doesn't start or
attachment doesn't
rotate.
Food is unevenly chopped.
Food is too finely chopped
or too watery.
Cup is leaking.
Unit doesn't turn on.
Unit doesn't turn off.
Doesn't mix well.
Lid/blade assembly will
not properly align to the
cup.

Replacement Parts

ORDERING REPLACEMENT PARTS

To order additional parts and attachments, please visit our website: www.ninjakitchen.com or feel free to contact
customer service: 1-877-646-5288.
16
1.877.646.5288
POSSIBLE REASONS & SOLUTIONS
• For the cups, make sure that the tabs are seated in the slots and
turned clockwise.
• Either you are chopping too much food at once, or you are not
pulsing properly. Reduce the amount of food in the cup.
• The food has been over processed. Use short pulses for best
results. Press down on the cup in short intervals.
• Make sure that your lid or blade assembly is properly assembled to
the cup. Leaking may occur if it is misaligned when twisted onto
the cup. Turn the lid tightly clockwise.
• Make sure the unit is plugged in.
• Rotate and press down on the cup to turn the unit on.
• Make sure the blade assembly is properly assembled to the cup and
that it is not misaligned.
• Unplug the power cord from the electrical outlet and call customer
service for support.
• Pulse ingredients for best results. Press down on the cup in short
intervals for even blending and chopping. For frozen ingredients,
pulse in short intervals of 2-5 seconds and repeat.
• Set the cup on a level surface. Place the lid or blade assembly on
top of the cup and align the threads so that the lid/blades sit flat
on the cup. Twist clockwise so that the lid/blades evenly align to
the cup until you have a tight seal.