Scope Of Delivery / Packing Unit; Preparation For Wall Or Ceiling Installation (Surface Mounted); Cable Exit From The Wall - Helios Mini Vent M1/100 N/C Notice De Montage Et D'utilisation

Installation and Operation Instructions
CHAPTER 2
SCOPE OF DELIVERY AND
ASSEMBLY
CHAPTER 3
MONTAGE
NOTE
MiniVent M1/100/120 N / C
2.0

Scope of delivery / packing unit

Leave the fan in its box until installation. Check that the fan is in good condition and has not been damaged in transit.
MiniVent M1/100/120 N / C
˜
—
–
3.0

Preparation for wall or ceiling installation (surface mounted)

The assembly and start-up of the fan unit should be carried out first after finishing of all other work and after the final
cleaning in order to avoid damages and contamination of the fan unit.
The position of the cable exit is variable (see fig.2/3).
fig.2
Cable exit in
the dark
section
user-defi-
ned.
min. 90 mm
*
Type M1/120 N / C
3.1

Cable exit from the wall

- Distance to the duct centre depending on cable exit 58/68* mm with a variable position under the casing.
- For a simple assembly an exit is recommended as shown (turnable by 90° in each case).
The optimal position is 45° each if the cable exit is directly at the position of the cable grommet.
- Duct inside diameter M1/100 N / C =100 mm or rather M1/120 N / C =120 mm
and distance to room corners: at least 90 mm
fig.1
–
Facia
›
—
Cover of control board including 2 x fastening screws
˜
Electronic control board
™
Casing with impeller
š
Guide vane removable at reduced installation depth
›
Removable back draught shutter
š
œ
Cable grommet

Assembley kit
2 x screws with plugs for wall mounting
œ
™

fig.3
Recommen-
ded cable
Cable runs under the casing. Cable
exit optional
length from the wall at least 180 mm.
0...-360 °, ide-
ally in each
case 45 °
Drill holes
3
UK