Honda Power Products HHH25D Manuel De L'utilisateur page 44

HHH25S:
• During operation, leave the trimmed branches, leaves, etc. on the
grass plate.
HHH25D:
• The rear handle can be turned to three positions (the CENTER
position and 90° clockwise, and counterclockwise).
• Upper part: Turn the rear handle to the CENTER position when you
trim the upper part of a hedge.
• Side part: When you use the cutter blade on the left side of your body,
turn the rear handle 90° counterclockwise. When you use the right
side of your body, turn the rear handle 90° clockwise (see page 42).
When you trim the side of a hedge, face the cutter blade to the hedge
and face the engine to your body.
CENTER position
GRASS PLATE
Turn the rear handle 90° clockwise.
Turn the rear handle
90°counterclockwise.
41