Dimplex Revillusion REV24-NB Guide D'installation Et D'utilisation page 16

Operation
Standby
Flame
Heat
Heat Disable
Thermostat
Control
Temperature
Display
(°C ↔ °F)
Flame Speed
Heat Mode
360° Light
Light
Sensor
Flame Accents
16
Press to turn the unit on or put it in standby mode.
When the unit is turned back on, it will retain the previously used settings.
Press to turn the flame effect on or off.
Press to turn the heat on or off.
The fireplace can be operated in heat only mode by turning off the flame and color
effects.
Press and hold and
function. This action must be performed on the hidden touch controls.
When the heat is disabled and either the
display.
Press or to adjust the temperature setting of the thermostat.
When the temperature setting is adjusted, the set temperature will flash for 2 seconds,
then the ambient room temperature will be displayed briefly.
The temperature can be set from 5° C to 37° C (41° F to 99° F).
Press and hold and
performed on the hidden touch controls.
Press multiple times to toggle through the flame speeds (minimum, medium,
maximum). The display will show the current speed number, F1, F2, F3, or F4.
Press multiple times to toggle through the heat modes (Normal, Eco and Boost).
Normal is indicated with a Nor on the display, ECO is indicate by an Eco on the display
and Boost is indicate by a b20 on the display. In boost mode, a time is set initial for
20 minutes and the display will indicate b19, b18, etc as the time counts down. This is
shown by pressing the heat mode button.
Press repeatedly to cycle through the different lighting options:
0 - Off
1 - White
2 - Yellow
3 - Red
This feature is only available when the flame effect is on.
Press to turn the ambient light sensor on or off.
The light sensor will adjust the brightness of the fireplace based on the ambient light in
the room.
This feature is only available when the flame effect is on.
Press repeatedly to cycle through the different flame accent options:
Yellow and red flame base ( r)
Orange flame base ( o )
Flame base off
This feature is only available when the flame effect is on.
at the same time for 2 seconds to disable or enable the heat
, , or
at the same time for 2 seconds. This action must be
is pressed, --- will appear on the
www.dimplex.com