Dimplex Revillusion REV24-NB Guide D'installation Et D'utilisation page 10

Installation
2. Remove the screws that secure the electrical cover
in the top right corner at the back of the firebox to
complete the wiring.
3. If hardwiring, complete the wiring according to
instructions in the Electrical Installation section
(pages 12–13). Reinstall the electrical cover after
completing wiring.
4. Place the firebox into the framed opening. Level with
shims if necessary.
WARNING: The built-in electric firebox must NOT be
in direct contact with any building vapor barrier or
insulation.
CAUTION: The front of the firebox must not be
recessed as this will prevent adequate airflow out of
the heater.
5. Remove inner decorative side panels from the
fireplace (attached magnetically) by tilting the top
inwards, then pull up and out. (Figure 4)
6. Secure the firebox to the frame using the four
bendable mounting flanges on the sides of the
firebox and suitable hardware (not included).
(Figure 5)
7. Reinstall the inner decorative side panels by inserting
the bottom first, then tilting upward to place.
8. Spread the tumbled glass embers over the white
portion of the ember bed.
9. Install the front glass. (Reference page 11)
10
Figure 4
Figure 5
Add tumbled
glass embers
www.dimplex.com