Operating Your Appliance - Frigelux Spnf177Bi Manuel D'instructions

Cleaning before use
Wipe the inside of the fridge with a weak solution of bicarbonate of soda. Then rinse with
warm water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy
water and dry completely before replacing in the fridge.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the fridge. DO
NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30
minutes before switching back on to allow the coolant fluid to settle.
Before filling your fridge
Before storing foods in your fridge, turn the fridge on and wait for 4 hours, to make sure it is
working properly and to allow the fridge to fail to the correct temperature.

4. OPERATING YOUR APPLIANCE

Temperature Control
Display
1 LED 1: 8°C
2 LED 2: 4°C
3 LED 3: 2°C
4 LED 4: Super cool
Display:
Once the product is turned on, all LED lights will light up for 3 seconds, while the start-up
buzzer will sound and then the refrigerator will operate to the default setting (LED3 light
which means 4°C is on).
•
If
there is no failure, it shows the actual temperature setting of the refrigerator.
•
In the event of failure, the corresponding LED light will blink:
Error code
LED1 / LED2 flashing
LED1 / LED3 flashing
LED2 / LED4 flashing
LED1 / LED4 flashing
Temperature Setting:
Each time the temperature setting button "B" is pressed once, the temperature setting
Button
A Standby button
Adjusting the temperature of
B
the refrigerator
Description
Refrigeration temperature sensor fault
Refrigerator defrost sensor fault
Communication card fault
Ambient temperature sensor fault
28