Liemke LUCHS–1 Mode D'emploi page 35

There are three alignment profiles so you can use the
LUCHS -1 for three separate rifles with the respective align-
ment profiles.
> Toggle through the G1, G2, G3 profiles using the UP and
DOWN buttons.
> Select the profile you want to use by clicking the MENU
button.
Important: Make sure the windage/elevation are both set to
zero before shooting. If a lot of adjustment is dialed in, you
might miss your target completely.
> Shoot a group at your sight-in distance through the
LUCHS -1.
> Measure the deviation from the point of aim to the point
of impact (center of the group)
In the Shot Alignment submenu, you can adjust the point
of impact for elevation and windage and set the minimum riflescope magnification by
following the directions on the screen
> Toggle through vertical adjustment/horizontal adjustment/icon display setting by
clicking the Menu button
One adjustment step equals 2.76 cm/100 m. The amount of adjustment from center will
be displayed on the screen. The „+" sign indicates a correction of the point of impact
up and to the right, the „-" sign indicates a correction of the point of impact down and
to the left.
In this submenu you can also adjust the icon display setting for the minimum magnifica-
tion of your riflescope. You can choose between 2,5x, 3,0x and 4,0x. This setting allows
the menu items to be displayed so they are all visible but at the edge of the field of
view for typical riflescopes of those magnifications. These magnification values are only
guidelines, choose the setting that best matches your riflescope's field of view at your
preferred magnification.
> Long press the MENU button to save and return.
LUCHS -1 · Operating Manual 09 / 2021
E
N
34
–
35