Maytag MVWB965HW Guide D'utilisation Et D'entretien page 19

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/owners
(in Canada, www.maytag.ca/owners) for assistance and to possibly avoid a service call.
If you experience
Washer Not Performing As Expected (cont.)
Not cleaning or
removing stains (cont.)
Odors
Fabric Damage
Possible Causes
Not using HE detergent or using too
much HE detergent.
Not using correct cycle for fabric type.
Not using dispensers.
Not washing like colors together.
Monthly maintenance not done as
recommended.
Not using HE detergent or using too
much HE detergent.
Sharp items were in pockets during
wash cycle.
Strings and straps could have tangled.
Items may have been damaged
before washing.
Fabric damage can occur if the load is
tightly packed.
Garment care instructions may not have
been followed.
Liquid chlorine bleach may have been
added incorrectly.
The suds from regular detergent can prevent washer from operating
correctly.
Use only HE detergent (liquid only in the dispenser). Be sure to
measure correctly.
Always measure detergent and follow detergent directions based
on load size and soil level.
Use a higher soil level cycle option and warmer wash temperature
to improve cleaning.
If using Rapid Wash cycle, wash only a few items.
PowerWash
®
Use cycle for tough cleaning. See the "Cycle Guide"
to match your load with the best cycle.
Use dispensers to avoid chlorine bleach and fabric softener staining.
Load dispensers before starting a cycle.
Avoid overfilling.
Do not add products directly onto load.
Wash like colors together and remove promptly after the cycle
is complete to avoid dye transfer.
Run the Clean Washer cycle after every 30 washes. See "Washer
Care" in "Washer Maintenance."
Unload washer as soon as cycle is complete.
Use only HE detergent (liquid only in the dispenser). Be sure to
measure correctly.
Always follow the detergent directions.
See "Washer Care" section.
Empty pockets, zip zippers, and snap or hook fasteners before
washing to avoid snags and tears.
Tie all strings and straps before starting wash load.
Mend rips and broken threads in seams before washing.
Load items in loose heaps evenly around the agitator. Load with dry
items only.
Load items should move freely during wash to avoid damage.
Use cycle designed for the fabrics being washed.
Add only one or two additional items after washer has started.
Use PowerWash or Bedding cycle for higher water fill, or select the
®
Deep Fill setting. See "What's Under the Lid" and the "Cycle Guide"
chart to match your load with the best cycle.
NOTE: Deep Fill is not available in the Normal cycle mode.
Always read and follow garment manufacturer's care label
instructions. See the "Cycle Guide" to match your load with
the best cycle.
Do not pour liquid chlorine bleach directly onto load. Wipe up
bleach spills.
Undiluted bleach will damage fabrics. Do not use more than
recommended by manufacturer.
Do not place load items on top of bleach dispenser when
loading and unloading washer.
Do not use the liquid chlorine bleach and Oxi products at the
same time.
Solution
19