Bosch SHX5AVF5UC Notice D'installation page 15

14
Do Not Over-tighten or
Remove Terminal Screws
15
Do Not Over-tighten or
Remove Terminal Screws
16
plate back into the junction box and
tab on the right side of the strain
relief plate is outside the junction
box as you slide it into place.
Note: Do not loosen or remove
terminal screws! Damage may
occur. Bend the wires so the
exposed leads can reach the
appropriate contacts. Insert the
black (hot) wire into the left opening
white (neutral) wire in the middle
opening of the terminal strip marked
(ground) wire into the right opening
Hand tighten only. Do not use
power tools.
stripped wire shows above
and below the terminal screw.
screws, but do not over-tighten
or damage may occur.
13