Hopper, Filter And Suction Pipe Cleaning, Gasket Check And Suction Fan Bearing Lubrication - Nilfisk RS 850 Manuel D'utilisation

Masquer les pouces Voir aussi pour RS 850:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance
Engine oil change
Diesel engine oil fi lter replacement
Fuel fi lter element replacement
Nut and screw tightening and leakage check
Lubrication
Engine coolant line check
Hydraulic system oil suction fi lter replacement
Hydraulic system oil drain fi lter and tank breather fi lter
replacement
Engine fuel fi tting and screw tightening
Glow plug check
Injector check, cleaning and calibration
Engine air fi lter replacement
Climate control system air fi lter replacement
Alternator and fan belt replacement
Climate control system belt replacement
Fuel tank cleaning
Engine coolant change
Hydraulic system oil change
Starter carbon brush check
Brake system check
Turbocharger check
Minor engine overhaul
Major engine overhaul
(3) Or every year
(4) Or every two years
(5) After 4,000 hours
(6) After 8,000 hours
(7) Contact an authorised VM Motori S.p.A. workshop.
(8) For the relevant procedure see the Service Manual, at any Nilfi sk Service Center.
HOPPER, FILTER AND SUCTION PIPE CLEANING, GASKET CHECK AND SUCTION FAN BEARING
LUBRICATION
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing cleaning procedures using compressed
air or water gun.
Preliminary operations
1.
Empty the hopper (7, Fig. G), drive the machine to a cleaning/washing appointed area, then engage the parking brake (13, Fig.
E).
2.
Lift and dump the hopper (7, Fig. G), according to the procedure shown in the relevant paragraphs.
3.
Install the lid support rod (17, Fig. F), according to the instructions shown on the relevant paragraph.
Hopper cleaning (after every use)
4.
Clean the hopper (1, Fig. F) and the defl ector (14) with pressurized water.
5.
Carefully check the suction sealing gasket (19, Fig. F) for integrity, and replace it if necessary.
Running-in pe-
Every 10
riod (after the
hours or
fi rst 50 hours)
before use
(8)
(8)
(8)
(8)
RS 850
33014576(4)2008-02 A
USER MANUAL
Every
Every
Every
150
300
500
hours
hours
hours
(3)
(3)
(3)
(8)
(8)
(8)
(8)
(8)
(8)
(8)
(8)
(4) (8)
ENGLISH
Every
Every
1,000
2,000
hours
hours
(8)
(8)
(8)
(3) (8)
(8)
(8)
(8)
(5) (7) (8)
(6) (7) (8)
31

Publicité

Table des Matières
loading

Table des Matières