Ice Maker (On Some Models) - Whirlpool W11224753 Instructions D'utilisation

Temperature Control (mechanical models)
For your convenience, the Temperature control is preset at the
factory. When you first install your refrigerator, make sure the
control is still preset as shown.
Recommended Setting "3 Snowflakes"
Cooling Off/On
Move the dial control to the word OFF. To turn cooling back
■
on, move the dial control to the desired temperature setting.
Temperature Control (electronic models)
Recommended Setting
Cooling Off/On
To turn off Cooling, press and hold the Temperature Setting
■
button for 4 seconds, until all lights turn ON for 1 second. To
turn cooling back on, press and hold the Temperature Setting
button again for 4 seconds.
NOTE: Neither compartment will cool when the control is set
to OFF.
Adjusting the Temperature Control (mechanical and
electronic models)
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the chart below as
a guide.
NOTE: Except when starting the refrigerator, do not adjust the
control more than one setting at a time. Wait 24 hours between
adjustments for the temperature to stabilize.
Move the dial to the desired number of snowflakes from
■
(1 least cold to 5 coldest).
OR
Press the Temperature Setting button to toggle among the
■
three LED lights which indicate the temperature setting.
Reading from left to right, the LED in the first position is the
least cold. The LEDs indicate increasingly colder settings as
you continue to the right.
8
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too little
ice
REFRIGERATOR too cold
FREEZER too cold
Airflow Control
The Airflow control regulates the amount of air flowing between
the freezer and the refrigerator compartments.
When you plug in the refrigerator for the first time, turn the Airflow
control to the Recommended setting.
Adjusting the Airflow Control (Freezer Temperature Control)
If you want to temporarily increase the cold airflow to a specific
compartment, adjust the control.
Max - Increase airflow to the freezer (this will make the freezer
■
colder).
Min - Increase airflow to the refrigerator (this will make the
■
freezer warmer).
IMPORTANT: Once the performance is achieved, return the
Airflow control to the Recommended setting to keep the
refrigerator operating at optimum efficiency.
CONDITION/REASON:
Heavy ice use
Hot room temperature
Large quantity of groceries
Ice Maker
(on some models)
For products without any part of the ice dispensing circuit, ice
maker and internal water circuit parts can only be installed by the
Manufacturer or by its Service Agent.
For Easy Connect (ice maker ready) products, ice maker can be
easily installed by the User, following instruction given with the kit.
In "Accessories" part of this manual you can find the ice maker
part number to be purchased.
Turning the Ice Maker On/Off
NOTE: Do not force the wire shutoff arm up or down.
To turn on the ice maker, simply lower the wire shutoff arm.
■
NOTE: Your ice maker has an automatic shutoff. As ice is
made, the ice cubes will fill the ice storage bin and the ice
cubes will raise the wire shutoff arm to the OFF (arm up)
position.
ADJUSTMENT:
TEMPERATURE Control one
setting higher
AIRFLOW or TEMPERATURE
Control one setting higher
TEMPERATURE Control one
setting lower
AIRFLOW or TEMPERATURE
Control one setting lower
ADJUSTMENT:
Max
Max - To maintain ice making
production rate
Min - To quickly chill food and
beverages