Electrical Connections - Warn ZEON WINCH Guide D'installation Et D'operation

Mounting Orientation
(4) M10 x 1.5 fl anged
locknut
(4) M10-1.5 x 35
Figure 2 Horitontal Feet Down Orientation
(4) M10 x 1.5 fl anged
locknut
Figure 3 Horizontal Feet Forward Orientation
MOUNTING
(2) M10-1.5 x 35
*(2) M10-1.5 x 40
(found in separate bag)
WARN INDUSTRIES
9

ELECTRICAL CONNECTIONS

Step 2 - Install the Wiring
To prevent serious injury or death. Always
WARNING
place the supplied terminal boots on wires and terminals as
directed by the installation instructions.
To prevent serious injury or death from
WARNING
electrical fi re:
Never route electrical cables across sharp edges.
Never route electrical cables near parts that get
hot.
Never route electrical cables through or near
moving parts.
Avoid pinch and wear/abrasion points when
installing all electrical cables.
Always insulate and protect all exposed wiring
WARNING
and electrical terminals.
NOTICE A fully charged battery and good connections are
essential to the proper operation of your winch. The minimum
requirement for a 12 volt DC battery is 650 Cold Cranking Amps.
Route battery connection cables in areas which
will not cause them to chafe or cut through the
insulation causing a potential short circuit.
The winch power wire must be routed to the
battery. A direct battery connection of the power
(red) and ground (black) cable is required. WARNING!
Do not connect ground to vehicle chassis.
Routing the battery cables may require removal
of vehicle facia or body parts.
Always route battery cables along a path that
allows the cables to be secured with zip ties.
83449A2 83449A2
Loose or unsecured power cables can cause
WARNING
serious injury or death.
Always protect power cables from sharp edges,
areas that get too hot to touch with your hand and
any moving parts.
1. Plan the routing path.
2. Loosely secure power cables along path.
3. Confirm power cables are protected from sharp
edges, heat and moving parts. Consider chassis
flex and vibration which might damage cable.
4. Carefully inspect electrical cable routing. Is
it neat and tidy? Zip tie and secure electrical
cables. Zip ties should be snug, but not cutting
into wire insulation. Use electrical tape, pieces
of rubber hose or electrical conduit to protect
electrical cables and wire harness where
needed to avoid electrical cable insulation wear
or abrasion.
5. Attach battery cables, red (positive) cable
FIRST, black (negative) second. Install boots
as appropriate to protect connections. Torque
battery terminal fasteners as directed by vehicle
service manual.
Upon completion of installation, check winch for
proper operation.
Step 3 - (Optional) Synthetic Rope
Installation
For synthetic rope models, be sure to fully read
the WARN Synthetic Rope Installation Instruction
manual for detailed synthetic rope installation
instructions.
Ground (Black) Cable
Power (red) Cable
Figure 4 Electrical Diagram
WARN INDUSTRIES
10