Installation; Assembly; Installing The Dust Blower; Installing The Dust Spout - PEUGEOT Energyscroll 400 Manuel D'utilisation

1. Quick release tension lever
2. Dust blower
3. See trough blade guard
4. Upper blade holder
Motor
Throat
Maximum cutting height
Table tilt
Blade lenght
The noise level of this machine during cutting is as follows :
Sound pressure level : 72,9 dB(A)
Sound power level : 85,9 dB(A)
Uncertainties equal to 3 dB.
WARNING! For your own safety, never connect the plug to power source outlet until all assembly steps are completed
and you have read and understood the safety and operational instructions.
1. Lift the saw by the frame and base and place scroll saw on the workbench.
Installing the dust blower (Fig.2)
The dust blower can blow away the sawdust on the workpiece so that you can see your pre-drawn lines or patterns easier.
1. Straighten the flexible dust blower.
2. Insert the plastic tube into the flexible dust blower and thread in the upper arm.
3. Bend the flexible dust blower to direct the airflow at the blade and workpiece.
Installing the dust spout (Fig.2)
1. Attach the dust spout to the front side base using the two pan head screws supplied.
NOTE : The dust spout can be connected to a dust extractor, which will provide fast and efficient removal of sawdust from your
machine.
Installing the blade guard (Fig.3)
Insert the blade guard assembly into the hole at the front of the upper arm and tighten it with the blade guard lock knob.
Installing the blades (Fig.5, 6)
NOTE : The teeth of the blade should always point downward to avoid uncontrollable lifting of the workpiece.
PLAIN-END BLADES
1. Lift up the quick release tension lever to release the tension of the blade. (Fig. 5)
2. Make sure the slots on the upper and lower blade holders are slightly wider than the thickness of the blade.
3. Insert the blade in the lower blade holder slot then tighten the set screw with a T-handle wrench supplied through the access
hole on the side cover. (Fig. 6)
4. Press the upper arm down and insert the other end of the blade into the upper blade holder slot then tighten the knob. (Fig. 6)
5. Lower the quick tension lever and turn the lever clockwise for proper tension. (Fig. 5)
NOTE : If the lever is difficult when lowered, turn it anticlockwise to loosen the blade tension.

INSTALLATION

Know your scroll saw (Fig.1)
5. No volt release (NVR) switch
6. Table lock handle
7. Dust spout
8. Blade storage
Specifications
110W, 230V, ~, 50Hz
406 mm
50 mm
0° - 45° left
127 mm

ASSEMBLY

1
Cutting speed 1450 min¯¹
Blade stroke 19 mm
Work table 436 x 260 mm
Dimension 635 x 320 x 395 mm
Weight 17 kg