Delivery Content - Deltec Zeolite Reactor ZA 509 Manuel D'utilisation

Zeolite is a mineral with the ability to adsorb many unwanted substances from aquarium
water such as nitrogen compounds and various metals.
The use of the unique Deltec ZA reactors is a very efficient method to achieve ultra-low
nutrient conditions in you aquarium.

Delivery content

- Main body
- Lid with piping
- 24V DC controllable pump
- 1 supply of Deltec Adzolithe
Also required (not included):
feedpump, please refer to technical data
-
silicone hose
-
Timer
-
The Zeolite in conventional Zeolite reactors needs to be manually agitated several times a
day. The agitation in the Deltec reactor happens automatically through the DC pump, via a
timer (the timer is not included). The frequency of the agitation can be selected and evenly
spaced through a 24 hours period.
The reactor operates on the fluidization principle, using much finer grain Zeolite. This
provides a much larger effective surface area resulting in more efficient adsorption.
There is no channeling effect as is normal with conventional Zeolite reactors, self-cleaning,
no buildup of sediments inside the reactor.
Before installing the Zeolite Reactor, please check for any damage.
Deltec Zeolite Reactors are built as pressure vessels and can be installed inside or
anywhere outside the filter sump or aquarium.
Wash the Zeolite thoroughly with tap water
-
Open the lid of the reactor by turning it anti clockwise
-
Remove the lid including the top strainer plate and sponge
-
Plug the center feed tube with the cap located at the top of the lid to prevent Zeolite
-
entering the feed pipe by accident
Fill the reactor with the right amount of Zeolite
-
Remove the cap from the center tube
-
Refit the strainer plate, sponge and lid
-
Submerge the feed pump in the sump or aquarium and secure the outlet hose in a
-
safe position in the sump or aquarium
Switch on the feed pump with the tap fully open.
-
surface- Allow the pump to run for one or two minutes until most air has been bled
out of the reactor and the clear pressure pipe of the DC pump on top of the lid is
filled with water
start the DC pump and select maximal flow
-
wait until the air is fully bled out of the pipe system and no more air bubbles are
-
visible
Deltec Zeolite Reactor
Installation
Starting up
t must end below the water
I
-6-