Ryobi PBC-3046YB Manuel D'utilisation page 26

PBC-3046YB manual
GB
F D E
DESCRIPTION
69. Trimmer attachment
70. Coupler
71. Knob
72. Power head shaft
73. Guide recess
74. Button
75. Positioning hole
76. Adjust the strap hanger
ASSEMBLY
ATTACHING THE POWER HEAD TO THE
TRIMMER ATTACHMENT
WARNING
Never attach or adjust any attachment while
power head is running. Failure to stop the engine
may cause serious personal injury.
The trimmer attachment (69) connects to the power head
by means of a coupler (70) device.
Loosen the knob (71) on the coupler of the power
■
head shaft (72) and remove the end cap from the
attachment.
Push in the button (74) located on the trimmer
■
attachment shaft. Align the button with the guide
recess (73) on the power head coupler and slide the
two shafts together.
Rotate the trimmer attachment shaft until the button
■
locks into the positioning hole 75.
Note: If the button does not release completely in
the positioning hole (75), the shafts are not locked
into place.
Slightly rotate from side to side until the button is
■
locked into place.
Tighten the knob securely.
■
WARNING
Be certain the knob is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious injury.
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
For removing or changing the attachment:
Loosen the knob.
■
Push in the button and twist the shafts to remove and
■
separate ends.
10/01/05 9:29 Page 19
I P NL S
English
DK N FIN GR H
HANDLE (Fig. 2)
Place the handle bar (18) in the bottom clamp (19)
■
located on the shaft (8) housing.
Note: The throttle trigger (9) must be mounted to the
operator's right side.
Insert the square tab of top clamp (17) into the
■
mounting hole of the bottom clamp.
Adjust the handle bar for best operator control in a
■
comfortable upright position.
Install the handle position adjustment knob (20) and
■
tighten securely
ATTACHING THE SHOULDER STRAP (Fig. 3)
Connect the latch (22) on the shoulder strap (4) to the
■
strap hanger (2).
Adjust the shoulder strap hanger to a balanced
■
position where the blade or cutter attachment will
suspend between 100mm to 300mm above the
ground surface.
Adjust the strap hanger to a comfortable position (76).
■
Note: To quickly release the product from the
shoulder strap, sharply pull the quick release tab (21).
MUFFLER GUARD ASSEMBLY (Fig. 4)
Remove muffler guard (27) and two screws (26) from
■
the owner's kits.
Attach the muffler guard to the rear housing (24).
■
Note: Make sure the bent end of the muffler guard (28)
fits securely into the opening of the rear housing (29).
Using the torx wrench supplied (25), install the two
■
screws and tighten securely.
GRASS DEFLECTOR AND BLADE GUARD USE
(Fig. 5)
Note: When converting from brushcutter to string trimmer
or string trimmer to brushcutter, make sure the correct
guard/deflector is being used.
BLADE GUARD (Fig. 6)
Attach the blade guard to the mounting bracket (30);
■
install the four screws (10-24 x 3/4 in.) from the top of
the mounting bracket through the blade guard (5) and
into the threaded mounting plates (32).
Using the torx wrench supplied, tighten all four
■
screws securely.
Note: When using the string head (36), the string
shield must be attached to blade guard.
19
CZ RUS RO PL