Speaker System Hookups - Sony TA-FA30ES Mode D'emploi

Tape deck, DAT deck, or MD deck
Amplifier
L
Ç
R
REC OUT IN
TAPE1/DAT
ç
Use the configuration above to connect the OUTPUT and
INPUT jacks of:
—a tape deck or DAT deck to the TAPE1/DAT jacks.
—a tape deck or MD deck to the TAPE2/MD jacks.
Turntable
1 Remove the shorting plugs from the PHONO jacks before
connecting the cables (but not unless you connect a
turntable).
Do not attach the shorting plugs to any set of the REC
OUT jacks. Doing so may stop output from the amplifier
or cause the unit to malfunction.
2 Connect the audio connecting cords.
Amplifier
PHONO
SIGNAL
GND
y
L
R
IN
3 Press CARTRIDGE to select the cartridge type.
Cartridge type
MM
MC
Note
To prevent hum, connect the earth lead to SIGNAL GND (y)
on the amplifier.
TV or video deck
Amplifier
L
Ç
R
IN
AUX
Tape deck
L
R
LINE LINE
OUTPUT INPUT
Turntable
Ç
Button position
ø
Ø
TV or video deck
L
R
LINE
OUTPUT

Speaker System Hookups

Overview
Here you learn how to connect speakers to the
amplifier. You can connect two pairs of speakers.
SPEAKERS MAIN SPEAKERS BI-WIRE
PHONO
CARTRIDGE
Ø MC ø MM
SIGNAL
GND
SPEAKERS
y y
L
R BI-WIRE L
R
IN
+ – – +
L L
R R
IN IN IN REC OUT IN REC OUT IN
R MAIN L
TUNER CD AUX TAPE2/MD TAPE1/DAT
IMPEDANCE USE (MAIN+BI-WIRE TOTAL) 4-16 Ω
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
(+)
(–)
Twist the stripped ends of the cord about 15mm. Be sure to
match the speaker cord to the appropriate terminal on the
components: + to + and – to –. If the cords are reversed, the
sound will be distorted and will lack bass.
Hookups
}
]
Getting Started
(+)
(–)
}
]
GB
5