Black & Decker 50 Po Guide D'utilisation page 9

Bagger Usage
NOTE: When all of the grass bags are full, place the tractor on a firm, level surface,
disengage the PTO, turn the tractor engine off and set the parking brake.
1. Pivot the seat forward and up.
2. Lift up bagger cover by pushing in on the rear, right-side tab with your right
hand, as seen in 1 of Figure 24, and lifting the cover with your left hand in the
center rear of the bagger cover, 2.
3. Do not remove the chute tube assembly from the tractor.
4. Remove the grass bags, as shown in Figure 25, by lifting each bag up (1) and
moving the bags away from the bag support assembly (2).
5. Empty the grass clippings at a proper disposal sight, use the handle at the
bottom of each grass bag. Holding the bag firmly, empty the contents.
6. Replace the grass bags in the reverse order and in the same orientation in
which they were removed, close lid, pivot down the seat, restart your tractor
and resume cutting your grass.
OPERATION
2
Figure 24
2
Figure 25
9
1
1